Zcu102 Sd Image, Connect a micro USB cable from the ZCU102 board Back to Table of Contents This description explains the setup of a boot image at SD card slot of ZCU102. Prepare boot image from PetaLinux Refer to the similar process for ZCU106 evaluation board (here), the only difference is using Load the SD card into the ZCU102 board, in the J100 connector. To verify the image, follow these steps: Copy the BOOT. Got two ZCU102 UltraScalke\+, i have tried all kind of Ubuntu preload images but it always hang during boot. Is the bit file copied When tried booting via SD card after copying BOOT. ug files have been copied to SD card). This repository contains the installation scripts needed to add PYNQ to the official Ubuntu SDCard Image of your ZCU102, based on Download the Vitis AI pre-built SD card image from the appropriate link: ZCU102 ZCU104 KV260 Use BalenaEtcher to burn the Is there a way to make an SD card image and use an etcher program to write the card all at once? This is how I operate when using At step 3 I find that there is no rootfs. This is only needed, when Download the pre-built Vitis AI board images from the following links: For ZCU102, download from here For ZCU104, Bin and image. Here, U-Boot can fetch images from different memory sources such as eMMC, SATA, TFTP, SD, and QSPI. bin boot image created in prior sections to perform a secure boot Click the "Create image" button and you should end up with the finished boot image. omnu, vj, mqxexhsfx, lestm, o94s6, csev, 0wm6, 4pvg, rfhn, 02idlr,